EAntenna Sloper 160m

EAntenna
SKU
17902.SL160
Eantenna Sloper 160m, length 17.7m
€100.84
without VAT, plus shipping
In stock, shipped in 3 to 4 days.

The EAntenna EASLP160S is a Lambda-1/4 antenna with a shortening coil to reduce the length of the antenna. The feeding point is located at the top of the mast. Like all Sloper antennas it works like a vertical antenna with a low elevation angle of the main lobe. This gives very good results for DX. The mast gives a directional effect, the mast acts as a reflector. If a wooden mast or another non-conductive mast is used, a cable must be laid from the feed point downwards. The advantage of the sloper antenna is the very easy installation, its flat radiation and the easy adjustment. The bandwidth is approx. 75 kHz (SWR 2:1) with correct installation and average ground conductance, the minimum is at the lower end of the band (CW range). To adjust the antenna for the SSB range it has to be shortened slightly at the lower end, 5cm is usually sufficient.

This antenna does not contain a balun, but you can use a choke (1:1 balun) at the feed point. The antenna wire is 2mm thick and protected against UV radiation to achieve a long life span. The max. permissible transmission power is 2 kW. Weight only 1500g, length of the radiator wire 17.7m, required clamping length with some rope approx. 20m, required mast height for 45° guying approx. 14.2m.


Kontaktbild

Get in touch with us

phone

Tel.: +49 (0)7276 9668–0
Monday to Friday
09-12 am / 02-05 pm

Technical Data
Weight [kg] 1.50 kgs
ANtenna Type Sloper
Connector PL-Buchse
Max. Power [W] 2000 W
Height [m] 12.7 m
Impedance (Ω) 50 Ohm
Length [m] 17.7 m
Supported Bands 160m
There are no files to download.